How It Works

Here is how it works:

 

Step 1: Place the tray over the upper teeth without placing the tray in boiling water. Practice with your tongue on the roof of your mouth and touching the inside of the tray. Suck the air from the tray. This contours the guard to the inside surface of the teeth. When finished repeat with the lower tray.


Step 2: Bring water to a boil. The bowl should be at least 4″ deep to ensure the tray’s full immersion. Remove the container from the heat and place one tray in the hot but not boiling water. Leave the tray in water for 5 seconds. Make sure the edges do not fold onto each other.


Step 3: Lift the tray vertically from the water using the tab. Carefully and quickly place the tray around the teeth and then immediately place it to your teeth and press against it to form a shape according to your teeth.


Step 4: Once you are satisfied with the fit, trim the front tab away from the tray with scissors.


Step 5: Place a small bead of gel per tooth in the inside of the tray (.5cc or less per tray). The gel might irritate the gums if the trays are overloaded. Insert the trays very carefully keeping the gel on the teeth and away from the gums. The Gel Contains 44% Carbamide Peroxide.


Step 6: Wear the trays for 25 minutes (You can wear the trays for up to 45 minutes but do not exceed more than that). If sensitivity or irritation occurs, wait 24 hours between treatments and use less gel. Be sure to rinse trays thoroughly after use. Repeat process daily until you reach the desired shade.


 
Remineralization Gel Application:
The application of the Remineralization Gel will have the similar steps and should be done after your teeth whitening process. Wash and rinse your thermoform mouth tray before placing the gel. Application for remineralization should be done once after every 3-4 sessions of teeth whitening and should last for 5 minutes for best results.